SATA Raid + USB2.0 + 1394a 9 port PCI Host adapter . Integrates Serial ATA RAID (1.5 Gbps), USB 2.0 (480Mbps) and IEEE 1394 (400Mbps) in one PCI Host Adapter to upgrade your computer to have all advanced features!

• Provides Dual independent Serial ATA channels
• Provides RAID 0 and RAID 1
• Provides Three IEEE 1394 ( FireWire ) ports (2 External + 1 Internal)
• Provides Four USB2.0 / USB1.1 ports (3 External + 1 Internal)
• Supports Windows drivers

• PCI

  	Compliant with PCI Specification, revision 2.2.
  	32 bit, 33/66MHz fully compliant PCI host interface.
  	Integrated PCI DMA engine.

  
  
• High Speed Serial ATA RAID

  	Dual high speed serial ATA interface ports, each supporting 1st generation Serial ATA data rates (1.5Gb/s)
  	Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to 2 drives
  	Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on 2 drives
  	Fully compliant with Serial ATA 1.0 specifications
  	Independent 256-byte FIFOs (32 bit * 64 )
  	Features Serial ATA to PCI interrupt masking
  	Features Watch Dog Timer for fault resiliency deep) per Serial ATA channel for host reads and writes
  	Supports Spread Spectrum in receiver
  	Acts as NON-RAID when BIOS not configured RAID

  
  
• USB 2.0

  	Compliant with Universal Serial Bus Specification Revision 2.0 (Data Rate 1.5/12/480 Mbps)
  	Compliant with Open Host Controller Interface Specification for USB Rev 1.0a
  	Compliant with Enhanced Host Controller Interface Specification for USB Rev 0.95
  	Provides Four USB2.0 / USB1.1 ports ( 3 External + 1 Internal)
  	All USB ports can handle high-speed (480 Mbps), full-speed (12 Mbps), and low-speed (1.5 Mbps) transaction

  
  
• IEEE 1394 ( FireWire )

  	Compliant with IEEE 1394 Open Host Controller Interface specification release 1.1 and IEEE Std 1394a-2000
  	Provides three 1394 ports at 100/200/400 Mbps
  	Built-in FIFOs for isochronous transmit (2048 bytes), asynchronous transmit (2048 bytes), and receive (3072 bytes)
  	32-bit CRC generation and checking for receive/transmit packets